I am having a hard time finding information anywhere on the web on how to wire the magnetic encoder that I received with my motor from iPower. I have checked the datasheet from AMS, but when I try to follow the traces on the board to the 6 pin connector, I run into a few issues that don’t make sense…

Had some troubles connecting magnetic encoder AS5048A included with iPower Motors to Arduino DUE via SPI (confusing colors, switched connectors, etc.). For future references a short docu. [Magnetic_Sensor_AS5048A_SPI_Arduino_UNO_and_DUE_2023_05_29_Seite_1] [Magnetic_Sensor_AS5048A_SPI_Arduino_UN…

iPower Motor and SPI Wiring

hardware support

Martin-Kim January 27, 2021, 4:13am 5

I hope this help,

Haptic textures