Nicholas_Del_Rossi:
DRV8300
The library is driver agnostic. Voltage is irrelevant. You set the voltage as a parameter. I’ve used the library with a 600V IGBT driver. Other people, too.
Cheers,
Valentine
I am opening a new thread for that one, since the old one was for my TI driver.
@Franz_Schmidt
I was finally able to get a clean PWM low voltage signal out of the driver.
I found a few small errors that prevented me originally from getting results, due to me cutting too many corners when designing the board. Eventually I was able to contact an on-semi engineer who pointed out the biggest problem, which was really easy to solve, I had to connect the over-current sense to ground via 100R to bri…
That was reinpurpused heatsink from another project, but the mounting drills were close enough. I would put a mind stone, but you know how hard is to get one